Simple Solution to Leakage Problem of Submersible Pump

 When you use the submersible pump may be because the submersible pump leakage problems and some novice do not know how to do, how to judge where the wrong, Hope to help you. 

    First of all, we should know, submersible pump leaks are mostly due to aging seals, wear and tear caused by, in addition to replacing the new seals, there are no other submersible pump troubleshooting solution? 

    First, the submersible pump seals due to prolonged use of loss of elasticity, then remove the ring, and then find a piece of 0.3mm-0.5mm thick paper or cloth referred to as the original seal a little bigger pad installed in the concave bad , And finally installed on the original ring.

    Second, the nylon seal seat rubber seal wear, the ring can be removed, and then replace the location of the installation, if the sealing ring on the elastic spring lost elasticity or fracture, can remove the spring, with a suitable diameter steel wire or wire truss.

    Third, the first ring can be removed from the serious wear and tear of nylon seals, and then coated with butter asbestos rope, wrapped in stainless steel sleeve filled slightly higher than the original nylon seat, and then filled with butter, then nylon seat bolt pressure Tight compaction.

    Fourth, sealing box and cast iron seal between the loss of elasticity, can be removed from the cast iron tank ring, looking for a thick 0.6 to 1 mm thick cardboard cut into the same size, pad in the slot, and then the Seal into.

    Fifth, the oil hole rubber ring damage, can find a piece of tape, cut into slightly larger than the bolt hole, top plus flat pad, set in the bolt into the hole.